Tutorial:Removing Wig and body Changing for Pullip

Wig removing:
Tool Required Phillip head screwdriver(im using 3mm thick screwdriver)
You can choose anyside of the wig to pull it out..in the picture i choosed right side..

pull it gently until you see some open gaps...you can use your finger to pull it slowly after you find some open gaps...repeating the step using screwdriver if it is to hard to peel..

Body Changing Tutorial for Pullip
my case that i showing was changing from original pullip body to obitsu 27cm SBH L bust body..
choose the biggest newly neck joint that i circle...

(Optional)
in the picture i showed i removing the bust off for easily for me to took the neck joint part off..
you can either skip this step and just push down the rubber part of the neck in order to remove the iron pin inside...

push the iron pin off..by doing so you can either using something thin enough to go through...im using the same phillip screwdriver though..

Removing the original stock body...after you remove the original wig...follow by open up her head by screwing out all the screw...

The newly neck joint part i choosed just now...mark the line that you need to cut off...
in order to do so..i used saw first for making it easier to cut...then follow by using the cutter showed below...
This it It!!!...the end of your work...it fit nicely to your pullip head...